Use these settings when communicating DF-1 Serial to SLC and MicroLogix controllers via Channel 0 or 1747-UIC USB to DF1/DH485 convertor.
* IMPORTANT *
1770-PIC and NET-AIC modules are not supported.
· Select Adapter
· Enabled = CHECKED
· Device Type = Serial DF1
· Comm Port = COM1: ~ COM24:
· PLC Type = SLC/Micro (ENET/DH485/DF1)
· Link Speed = 9600 / 19.2k / 38.4k
LinkSpeed must match the baud rate of PLC Channel-0 setting.
· Checksum = CRC or BCC
Checksum must match the checksum of PLC Channel-0 setting
· TimeOut (3000ms) default. This is how long the INGEAR driver will wait for a response after sending a message on the serial link.
· Click Apply
· Click Done
Notes:
All other driver settings are not used for this configuration.